Maintenance of INA bearings on the pump

     Many of the maintenance of INA bearings are the same, but each industry has different maintenance. Today I will introduce the maintenance of the INA bearing on the pump.
(1) The pump that is newly put into use must be replaced with grease (oil) after 100 hours of operation, and then replaced once every 500 hours.
(2) Flow INA bearing lubricated with grease. After 1500 hours of operation, the grease should be replaced. The amount of oil to be filled should not be too much or too little, because too much or too little grease will cause the INA bearing to heat up. Generally, it is suitable to hold 1/2 to 2/3 of the volume of the INA bearing chamber.
(3) For INA bearings lubricated with lubricating oil, the amount of oil should be added to the specified position.
(4) The container containing lubricating oil or grease should be clean and should be sealed properly. There should be no dust, iron filings and other debris to avoid damage to the INA bearing.
(5) Motor INA bearings generally use sodium-based grease, which is characterized by high temperature resistance (125 ° C), but is easy to dissolve in water, so it can not be used for lubrication of pump INA bearings.

For more information and purchase please visit: https://www.supplyforever.com

Imported bearing storage and storage methods

     Precautions for use
Rolling inlet bearings are more accurate than general mechanical parts, so care should be taken when using them.
1) Keep the imported bearings and their surroundings clean
2) Careful and careful when using
If used carelessly, the imported bearings will have strong impact, which will cause injuries, indentations, breaks and other injuries on the imported bearings.
3) Use the right tools
4) Pay attention to the rust prevention of imported bearings
Avoid using it in wet areas, and wear gloves if you don't get sweat on it.
5) Users should be familiar with imported bearings
6) Formulate operational specifications for the use of imported bearings
a, the preservation of imported bearings
b. Cleaning of imported bearings and their surroundings
c. Inspection of the size and processing quality of the installation site
d, installation work
e, post-installation check
f, disassembly work {TodayHot}
g, maintenance (regular inspection)
h, lubricant supplement
Storage of imported bearings
Imported bearings are coated with an appropriate amount of anti-rust oil at the factory and packed with anti-rust paper. As long as the package is not damaged, the quality of the imported bearings will be guaranteed.
However, for long-term storage, it is recommended to store on a shelf 30cm above the ground at a temperature below 65% and a temperature of about 20 degrees Celsius. In addition, the storage place should avoid direct sunlight or contact with cold walls.

For more information and purchase please visit: https://www.supplyforever.com