Stone engraving machine engraving necessary daily maintenance and maintenance

The stone engraving machine is a precision numerical control equipment, and the necessary daily maintenance and maintenance is essential to the service life and accuracy of the machine. Please perform the maintenance and maintenance as described below.
1. The continuous running time is less than 10 hours per day to ensure the cleaning of the cooling water and the normal operation of the pump. The water spindle motor must not be dehydrated, and the cooling water should be replaced regularly to prevent the water temperature from being too high. In winter, if the working environment temperature is too low, the water in the water tank can be replaced with antifreeze.
Second, each time the machine is used, it is necessary to pay attention to cleaning. It is necessary to clean the dust on the platform and the transmission system, and regularly and weekly (weekly) lubricate the transmission system (X, Y, Z three axes). (Note: X, Y, Z three-axis polished rods are maintained with oil; high-speed butter is added to the screw; in winter, if the working environment temperature is too low, the screw, polished rod (square rail or circular guide) should be cleaned with gasoline first. Then add the oil, otherwise it will cause the resistance of the machine transmission part to be too large and cause the machine to be misaligned.)
Third, the maintenance inspection of the electrical appliance is, must cut off the power supply, until the monitor has no display and the main circuit power indicator is off, before proceeding.
Maintenance: Modification of the engraving machine parameters (Vihong system): Manufacturer parameter modification, (Enter password: NCSTUDIO click "OK") Workbench stroke: (depending on the model of the machine)
System parameters: The first four items are selected on the default basis.

Motor parameters: If the three axes are all screw drive machines, if the lead is 10, the motor parameter is 0.00625. If the lead is 5, the motor parameter is 0.003125; if the X and Y axes are rack drive, the Z axis is wire. For the bar drive machine, the motor parameters of the X and Y axes are all 0.0098175. The Z axis parameter is determined according to the lead lead. If the lead is 10, the motor parameter is 0.00625. If the lead is 5, the motor parameter is 0.003125.

Take-off frequency: 300 Z-axis maximum speed: 1000 Single-axis acceleration: 400 Curved acceleration: 300