Advertising engraving machine water will not cycle what is going on?

1. The pump power is too small to perform the water circulation activity from low to high.

2, the water is not often replaced, there are impurities in the water, blocking the water inlet of the motor, resulting in reduced pressure.

3. It is because a large amount of water rust accumulates in the spindle motor during long-term work, which hinders the normal circulation of water. This is also the most common cause. The solution is to change the water frequently.

What should I do if the advertising engraving machine does not circulate?

1. Check that the pump power is too small and replace it if the power is too small;

2. Change the water frequently.

Advertising engraving machine computer maintenance?

1. Clean the dust of the chassis regularly, pay attention to the heat dissipation of the chassis, and be careful that the industrial control card is faulty due to excessive dust.

2. Regularly defragment the disk and optimize the computer system.

3, regularly check and kill the virus, but pay attention to work can not open the anti-virus program to prevent interference work.

The use of advertising engraving machine cooling water?

1. Cooling water is a necessary condition for the normal operation of the spindle motor. If the cooling water is too dirty, it will cause serious damage to the motor. Therefore, the cooling water must be cleaned to ensure the normal operation of the pump.

2, pay attention to the water level, must not make the water-cooled spindle motor water shortage, so that the motor heat can not be exported in time.

3, pay attention to the ambient temperature, be careful because the water temperature is too cold and cause the water tank and water pipe to freeze.

4. Conditional antifreeze can be used for cooling.